Manual Results

Showing 1-10 of 22 results

NI 6351 Device Specifications
This document contains specifications for the NI PCIe-6351 and NI USB-6351 X Series MIO devices. Specifications listed are typical at 25 °C, unless otherwise noted.
Edition Date: June 2016

NI-DAQmx First Available Hardware Support
This page shows supported versions of the NI-DAQmx hardware driver with the Microsoft Windows operating system. Reference this information to ensure you install the correct version when upgrading or updating ...

DAQ Multifunction I/O (MIO) and Simultaneous Multifunction I/O (SMIO) Devices Calibration Procedure
This document contains information about calibrating National Instruments B, E, M, S, and X Series data acquisition (DAQ) devices, which include the following devices: NI 6010, NI 6013/6014/6015/6016, ...
Edition Date: October 2019

X Series User Manual
The X Series User Manual contains information about using the National Instruments X Series data acquisition (DAQ) devices with NI-DAQmx 19.0 and later. X Series devices feature up to 208 analog input ...
Edition Date: May 2019

USB-6351 Product Certifications
This page documents all the applicable standards and certifications for the USB-6351 and provides downloadable certifications.

USB-6351 Dimensional Drawings
This page provides dimensional drawings for the USB-6351.

USB-6001 Pinout - Multifunction I/O Device Manual
Signal Descriptions Signal Reference Description AI GND — Analog Input Ground—The reference point for single-ended analog input measurements. AI <0..7> Varies Low-cost USB SE 1st pgh Analog Input Channels—For ...

USB-6289 Mass Termination Pinout - Multifunction I/O Device Manual
[SPC 610/16: Added conreffed Default C/T Terminals table when I noticed its absence on review. Default Counter/Timer Terminals Counter/Timer Signal Default PFI Terminal CTR 0 SRC PFI 8 CTR 0 GATE PFI 9 ...

USB-6009 Pinout - Multifunction I/O Device Manual
Signal Descriptions Signal Reference Description GND — Ground—The reference point for the single-ended analog input measurements, analog output voltages, digital signals, +5 VDC supply, and +2.5 VDC at ...